Video from my You tube channel

Subscribe to My You tube channel

Moment Diagrams Constructed by the Method of Superposition



Shear and moment diagrams are very important to conduct a structural analysis for a member or structure. Also, the designer should know the shear and moment values applied to a member to determine the amount of reinforcement and member dimension. A structural engineer should have the ability to draw shear and moment diagrams. Superposition is one of the methods used to draw the moment diagram. In this method, the loads applied on beam taken individually. The moment diagram for each load drawn separately. The moment diagram for a beam is the sum of these diagrams for each load case. Figure 1 shows most of the load cases for a beam.

Figure 1







To understand the principle of superposition let consider the simply supported beam in figure 2. the simply supported beam in figure 2 subjected to a distributed load of 4k/ft over half of the beam and moment of 300 k.ft at the middle of the beam. First, we will calculate the reaction at support A and B. for simplification, we can change the support at A or B  to the cantilever. In this example, we change the support at A. then we will draw moment diagram for distributed load separately. Then the moment diagram for the moment at the middle of the beam, and the moment diagram for the reaction at B. the moment diagram for each load case is shown in figure 2-B. We can apply the same steps without changing the support as shown in figure 3. 
Figure 2

Figure 3







Comments

Post a Comment

Popular posts from this blog

Field density test-sand cone method

Zero force member for truss

Example 1: Design of one-way slab

Determinate and indeterminate structure

Pile cap

Tributary area(Loading)

Flakiness Index and Elongation Index of Coarse Aggregates

Types of structure

Strength reduction factor ∅

Heavyweight concrete